Features:
Table Base: |
| Precision Machined Cast Iron Base With Milled Keyways To Guide Fences; Disc Set Flush With Base. |
Floor Stand: |
| Close Coupled Heavy Gauge Sheet And Angle Steel. |
Spindle & Pivot: |
| Spindle Mounted On Preloaded And Sealed Bearings; With V-Belt Drive Completely Enclosed. |
| Pivot Uses Timken Bearings Lubricated For Life. |
Production Rate: |
| The F526 Is Capable Of Cycling Up To 10 Strokes Per Minute. However, Actual Production Rates Vary With The Type And Width Of Material To Be Cut. |
Optional Extras: |
| Power Downfeed Of Sawhead, Clamps, Measuring System And Table Supports. |
Specifications:
Saw Type: |
Straight Cut-Off Saw |
Blade Capacity: |
20″ |
Arbor: |
1″ (25mm) With 5″ (127mm) Saw Collars. |
Motor HP: |
5 HP (Standard) |
| 8-1/2 HP, 10 HP, and 15 HP (*Optionally Available) | |
Motor Voltage: |
230/460 Volt Three Phase |
Starter: |
Magnetic Starter |
Cutting Capacity: |
|
| 90°: | 5-1/2″ (140mm) x 11-1/2″ (292mm) |
Actuation |
Manual Hand Operation |
| *Optional Two-Hand Anti-Tie-Down Power Downfeed Available | |
Air Pressure Requirement: |
80 PSI (5.6 kg/㎠) |
Air Consumption: |
3 CFM @ 80 PSI (0.09 ㎥/min @ 5.4 kg/㎠) |
Dust Collection: |
Two 4″ Dust Outlets |
| 1200 CFM Required | |
Machine Dimensions: |
48″ (122cm) Wide x 40″ (102cm) Front To Back x 70″ (178cm) High |
Machine Weight: |
850 Lbs. (386kg) |
