Features:
Floor Stand: |
| Close Coupled Heavy Gauge Sheet And Angle Steel. |
Spindle & Pivot: |
| Spindle Mounted On Preloaded And Sealed Bearings; With 2 Belt Drive Centered Between Bearings. |
| Pivot Uses Timken Bearings Lubricated For Life. |
Production Rate: |
| The CM60 Is Capable Of Cycling Up To 10 Strokes Per Minute. However, Actual Production Rates Vary With The Type And Width Of Material To Be Cut. |
Optional Extras: |
| Power Downfeed Of Sawhead, Clamps, Measuring System And Table Supports. |
Specifications:
Saw Type: |
Miter & Compound Cut-Off Saw |
Blade Capacity: |
16″ |
Arbor: |
1″ (25mm) With 3-1/2″ (89mm) Saw Collars. |
Spindle Speed: |
2800 RPM |
Motor HP: |
3 HP (Standard) |
| 5 HP (*Optionally Available) | |
Motor Voltage: |
230/460 Volt Three Phase |
Motor Speed: |
1725 RPM |
Starter: |
Magnetic Starter |
Cutting Capacity: |
|
| 45°: | 4″ (102mm) x 7-1/4″ (184mm) |
| 90°: | 4″ (102mm) x 10-1/2″ (267mm) |
| Compund: | 2-1/2″ (64mm) x 10″ (254mm) |
Actuation |
Manual Hand Operation |
| *Optional Two-Hand Anti-Tie-Down Power Downfeed Available | |
Air Pressure Requirement: |
75 PSI (5.4 kg/㎠) |
Air Consumption: |
1 CFM @ 75 PSI (0.043 ㎥/min @ 5.4 kg/㎠) |
Dust Collection: |
One 4″ + One 5″ Dust Outlet |
| 1100 CFM Required | |
Machine Dimensions: |
30″ (76cm) Wide x 26-1/2″ (67cm) Front To Back x 53″ (135cm) High |
