Features:
Table Base: |
Precision Machined and Ground Cast Iron Base With Milled Keyways To Guide Fences |
Floor Stand: |
Close Coupled Heavy Gauge Sheet And Angle Steel. |
Eight Foot Centers With Traveling Right Hand Carriage On Rack And Pinion |
Length Measuring Scale |
Spindle & Pivot: |
Uses CTD’s time tested 200R Series Saw Head |
Precision Ball Bearing Spindle And Pivot Shaft Are Sealed And Preloaded For Guaranteed Accuracy |
.001″ Alignment Of Spindle And Pivot Shaft |
Blade Guards: |
Completely Encloses Blade In Rest Position |
Lower Rotating Blade Guard Pivots Up Into Main Stationary Blade Guard As Saw Heads Pivot Down To Cut. |
Fences: |
On Each Side Of Blade Are Keyed To Base And Are Easily Adjustable Front To Back, And Side To Side |
Actuation: |
Two Inside Vertical Clamps Must Be Tripped By Foot Valve |
A Two-hand Anti-tie Down Maintained Contact Safety Control Will Work The Air Downfeed Of Saw Heads |
*An air filter/regulator/lubricator with auto drain is provided |
Production Rate: |
Up To 10 Strokes Per Minute |
*Actual Production Rates Vary With The Type And Width Of Material To Be Cut. |
Optional Extras: |
Power Downfeed Of Sawhead, Clamps, Measuring System And Table Supports. |
Optional Length Centers Available To 40 Feet 12m |
Specifications:
Saw Type: |
Double End Trim Miter Cut-off Saw |
Blade Capacity: |
14″ |
Arbor: |
1″ (25mm) With 2.5″ (64mm) Saw Collars. |
Motor HP: |
2 HP (Standard) |
(*3 HP Motor Optionally Available) | |
Motor Voltage: |
230/460 Volt Three Phase |
Starter: |
Magnetic Starter |
Cutting Capacity: |
|
45°: |
1.5″ (38mm) x 5″ (127mm) |
90°: |
2″ (51mm) x 7.75″ (197mm) |
Air Pressure Requirement: |
75 PSI (5.2 kg/㎠) |
Air Consumption: |
3 CFM @ 75 PSI (0.09 ㎥/min @ 5.2 kg/㎠) |
*Based on 10 Strokes/Minute | |
Dust Collection: |
Four 2″ Round Dust Outlets (Two On Each Sawhead) |
800 CFM Required | |
Machine Dimensions: |
120″ (305cm) Long x 32″ (81cm) Front To Back x 64″ (163cm) High |
Machine Weight: |
1,050 Lbs. (476kg) |