Features:
| Table Base: |
| Precision Machined and Ground Cast Iron Base With Milled Keyways To Guide Fences |
| Floor Stand: |
| Close Coupled Heavy Gauge Sheet And Angle Steel. |
| Eight Foot Centers With Traveling Right Hand Carriage On Rack And Pinion |
| Length Measuring Scale |
| Spindle & Pivot: |
| Precision Ball Bearing Spindle And Pivot Shaft Are Sealed And Preloaded For Guaranteed Accuracy |
| Blade Guards: |
| Completely Encloses Blade In Rest Position |
| Lower Rotating Blade Guard Pivots Up Into Main Stationary Blade Guard As Saw Heads Pivot Down To Cut. |
| Fences: |
| On Each Side Of Blade Are Keyed To Base And Are Easily Adjustable Front To Back, And Side To Side |
| Actuation: |
| Two Inside Vertical Clamps Must Be Tripped By Foot Valve, Then A Two-hand Anti-tie Down |
| Maintained Contact Safety Control Will Work The Air Downfeed Of Saw Heads |
| *An air filter/regulator/lubricator with auto drain is provided |
| Production Rate: |
| Up To 10 Strokes Per Minute |
| *Actual Production Rates Vary With The Type And Width Of Material To Be Cut. |
| Optional Extras: |
| Power Downfeed Of Sawhead, Clamps, Measuring System And Table Supports. |
| Optional Length Centers Available To 40 Feet 12m |
Specifications:
| Specifications: | |
| Saw Type: | Compound Double End Trim Miter Cut-off Saw |
| Blade Capacity: | 12″ |
| Motor HP: | 3 HP (Standard) |
| Motor Voltage: | 230/460 Volt Three Phase |
| Starter: | Magnetic Starter |
| Cutting Capacity: | |
| 45°: | 3.5″ (89mm) x 3.5″ (89mm) |
| 90°: | 2.5″ (64mm) x 7″ (178mm) |
| Air Pressure Requirement: | 75 PSI (5.2 kg/㎠) |
| Air Consumption: | 4 CFM @ 75 PSI (0.11 ㎥/min @ 5.2 kg/㎠) |
| *Based on 10 Strokes/Minute | |
| Dust Collection: | Four 4″ Round Dust Outlets (Two On Each Sawhead) |
| 900 CFM Required | |
| Machine Dimensions: | 120″ (305cm) Long x 32″ (81cm) Front To Back x 64″ (163cm) High |
| Machine Weight: | 1,200 Lbs. (544kg) |
