CTD F255RHC 14″ Straight Cut-Off Saw

$5,495.00

This rugged, accurate, and heavy-duty industrial straight cut-off saw uses CTD’s time-tested 200 series saw head.

The Model F255RHC uses the same sawhead as CTD’s M25RHC, but cuts at 90° only.

Completely Encloses Blade In Rest Position

Lower Rotating Blade Guard Pivots Up Into Main Stationary Blade Guard As Saw Heads Pivot Down To Cut

Made Of Iron Castings, Precision Machined And Ground With Milled Slots To Guide Fences

Sawhead Is Fixed At 90°

Fence Brackets Are Fit To Milled Keyways In Base And Are Easily Adjustable Front To Rear

Mounted On Pre-Loaded And Sealed Ball Bearings With 0.001&Quot; Alignment

Power Downfeed Of Saw Blade, Clamps, Magnetic Starters, Floor Stand, Measuring Fences, And Table Supports

Saw Type:	14″ Straight Cutoff saw
Blade Capacity:	14″
Arbor:	1″ (25.4mm) with 2-1/2″ (64mm) Saw Collars.
Motor HP:
Single Phase:	2 HP
Three Phase:	3 HP
Motor Voltage:
Single Phase:	115/230 Volt
Three Phase:	230/460 Volt
Motor Speed:	3450 RPM
Maximum Cutting Capacity:
90°:	4-1/2” (114mm) High x 9” (228mm)
Actuation	Manual Hand Operation
	*Optional Power Downfeed Available
Dust Collection:	Dual 2″ Dust Outlets
	*600 CFM Required For Each
Machine Dimension:	22″ (56cm) Wide x 27″ (69cm) Front to Back x 22-1/2″ (57cm) High
Machine Weight:	150 Lbs. (68kg)

Part#		Description		Price
AF	Air power feed unit. For precision, controlled cutting on			$3,195
	wood, plastic or non-ferrous sections. Air valves are
	mounted above saw head and reverse when two-hand
	control is released; includes one air clamp, air filter
	foot valve to actuate clamp, & pneu. timer & pressure gauge .
LEFT	Left Hand Assembly Option			$295
AG	Air Gun			$130
HYD	Same as AF but uses a Hydrocheck Unit with air cylinder for			$3,995
	controlled downstroke speed.
B3P153E	Skip Check for quick cycling of saw head using HYD until you start			$815
	cutting thru your parts (New machine install only)
AV/200	Automatic Valve. Valve actuator, used if item VC3, HC or SLS			$175
	is purchased without AF/HYD.
VC/200	Vertical air clamp (one side – please specify)			$325
HC/200	Horizontal air clamp (one side – please specify)			$350
PR	Pressure regulator			$160
SLS/200	Saw Blade lubrication system. Includes container, vacuum			$495
	Pump, nozzle, check valve and fittings.
BIOL/200	CTD biolube Lubrication System. Uses pulse system to			$1,795
	lubricate blades. System uses a minimum amount of high
	grade biodegradable oil per cycle.
B3P141	CTD biolube lubricant, per gallon			$95
10P01	CTD Soluble oil, per gallon			$40
	575 volt available – call for pricing		50Hz motor available – call for pricing