INVICTA TI-14 TILTING SHAPER W/3 ROLL POWERFEED
This is a very clean and well maintained example of an Invicta TI-14. Power is provided via a 7.5 hp motor. The spindle is capable of spindle speeds of 3,000, 6,000, 8,000, and 10,000 RPM and will run clockwise or counter-clockwise. You will also find a 3/4″ spindle, nuts, and a set of spacers along with an 1-1/4″ spindle, nuts, and a set of spacers for the larger spindle as well. Of course there is a spindle wrench so you can easily swap out the spindles. The 1-1/4″ spindle has 5-1/4″ under the nut while the 3/4″ spindle has 2-7/8″ under the nut. The spindle will tilt from -5° to + 45°. The machine also has a spindle lock and a foot brake……..and yes both function as they should. The original miter gauge is present. Up top you will find a 1 hp 3 roll power-feed that is every bit as clean as the shaper. So what are the downsides? The inner ring is missing and the mechanical tilt read out does not work…….not that it was all that accurate to begin with. We are including a magnetic angle finder which is accurate and will get you precisely to 0° or 45° or where-ever you are trying to get to. This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it. This is our guarantee to both you and your company!