CTD DM400 20" Double-End Miter Trim Saw » 360 Degree Machinery LLC

CTD DM400 20″ Double-End Miter Trim Saw

This rugged, accurate, and heavy-duty industrial double miter cut-off saw uses CTD’s time-tested 400 series saw head.

The DM400 uses two-hand anti-tie-down pushbutton control to safely initiate cutting. Pneumatic clamps are conveniently activated by the foot pedal.

Request a tailored quote now to get our best pricing for your needs, including any special discounts and accurate shipping costs!

Precision Machined and Ground Cast Iron Base With Milled Keyways To Guide Fences

Close Coupled Heavy Gauge Sheet And Angle Steel.

Eight Foot Centers With Traveling Right Hand Carriage On Rack And Pinion

Length Measuring Scale

Saw Heads Swivel From 90° To 45° Toward Each Other With Degree Markings And Pointer

Stops Are At 90° And 45°

Angular Adjustment Of Saw Head Away From Each Other Available As Option

Other Angles Possible

Uses CTD’s time tested 400 Series Saw Head

Precision Ball Bearing Spindle And Pivot Shaft Are Sealed And Preloaded For Guaranteed Accuracy

.001″ Alignment Of Spindle And Pivot Shaft

Completely Encloses Blade In Rest Position

Lower Rotating Blade Guard Pivots Up Into Main Stationary Blade Guard As Saw Heads Pivot Down To Cut.

On Each Side Of Blade Are Keyed To Base And Are Easily Adjustable Front To Back, And Side To Side

Two Inside Vertical Clamps Must Be Tripped By Foot Valve, Then A Two-hand Anti-tie Down

Maintained Contact Safety Control Will Work The Air Downfeed Of Saw Heads

*An air filter/regulator/lubricator with auto drain is provided

Up To 10 Strokes Per Minute

*Actual Production Rates Vary With The Type And Width Of Material To Be Cut.

Power Downfeed Of Sawhead, Clamps, Measuring System And Table Supports.

Optional Length Centers Available To 40 Feet 12m

Saw Type:	Double End Trim Miter Cut-off Saw
Blade Capacity:	20”
Arbor:	1″ (25mm) With 5″ (127mm) Saw Collars.
Motor HP:	5 HP (Standard)
	(8.5 HP, 10 HP, and 15 HP Motors Optionally Available)*
Motor Voltage:	230/460 Volt Three Phase
Starter:	Magnetic Starter
Cutting Capacity:
45°:	5.25″ (133mm) x 8″ (203mm)
90°:	5.5″ (140mm) x 11.5″ (292mm)
Air Pressure Requirement:	80 PSI (5.6 kg/㎠)
Air Consumption:	6 CFM @ 80 PSI (0.18 ㎥/min @ 5.6 kg/㎠)
	*Based on 10 Strokes/Minute
Dust Collection:	Four 4″ Round Dust Outlets (Two On Each Sawhead)
	900 CFM Required
Machine Dimensions:	156″ (397cm) Long x 54″ (137cm) Front To Back x 80″ (203cm) High
Machine Weight:	2,500 Lbs. (1,134kg)