RFS 36″ x 48″ FEED THRU RADIO FREQUENCY GLUER W/NEW TUBE $13,000

RFS 36″ x 48″ FEED THRU RADIO FREQUENCY GLUER W/NEW TUBE $13,000

This machine has a lot going for it and is very hard to duplicate. First of all it comes with a lay up table. In addition it is a feed thru model. This means not only ease of gluing up your panel, but you can also be laying up a panel while the machine is cycling! On top of this the machine comes with a brand NEW tube with a 1 year warranty. Not to be confused with a refurbished tube. It also has relatively low usage with 9,338 metered hours. Did we mention that this machine is also 230V/3 Phase? If this hasn’t gotten your attention how about the fact that if you were to insert 12 three inch wide boards that are 48″ in length and 3/4″ in thickness your cycle time would be under 1-1/2 minutes! The 3 kW generator cures approximately 300 sq. inches of glue line per minute. It features a 36″ X 48″ curing area (39″ X 51″ clamping area) with a max thickness capacity of 2″.  See below for full specs. This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it. This is our guarantee to both you and your company!

  • 36″ x 48″ curing area
  • 39″ x 51″ clamping capacity
  • 2″ maximum thickness capacity
  • 3 kW generator (cures approximately 300 sq. inches of glue line per minute)
  • Side pressure by (7) 4″ bore x 4″ stroke air cylinders
  • Top pressure by (2) 5″ bore x 12″ stroke air cylinders
  • Two-hand no-tie-down safety controls for closing the top platen
  • Layup table included
  • Electrical requirements: 50 amps @ 230 Volt 3-Phase