CTD DM200R 14″ DOUBLE END MITER SAW W/OIL MISTER $4,000

CTD DM200R 14″ DOUBLE END MITER SAW W/OIL MISTER $4,000

This is a nicely equipped double end miter saw with adjustable centers up to 8′. It adjusts via a hand wheel and features an optional Accurate Technologies Digital read out for ease of set up. Power is provided via twin upgraded 3 HP saw duty Baldor motors and the machine is also equipped with an optional Accu-Lube Oil Mist system which is hard to find on these machines. Further more you will find that each head has optional vertical and horizontal pneumatic hold downs. As you can tell there are a lot of “options” added onto this machine. You will also find pedestal dual palm safety controls. This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it. This is our guarantee to both you and your company!

Specifications:

  • Double end trim mitre saw

  • Blade Capacity: 14″

  • Magnetic Starter

  • 10 strokes per min.

  • Mitres up to 45°

  • Cutting Capacity:

  • 45°: 1½” X 5″

  • 90°: 2″ X 7¾

  • Uses our time tested 200R Series Saw Head; precision ball bearing spindle and pivot shaft are sealed and preloaded for guaranteed accuracy; .001 alignment of spindle and pivot shaft.

  • 1″ 25mm with 2-1/2″ 64mm saw collars; 3700 RPM of spindle.

  • 3 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motors, 60 Hz, 3450 RPM, with starters and voltage protection

  • Tables are precision machined and ground iron castings with milled keyways in tables to guide fences.

  • Four, 2″ round 51mm outlets are provided, two on each saw head for DM200R; 800 CFM required per saw head.

  • 10 strokes per minute; actual production rates will vary with type and width of material to be cut.

  • Saw heads swivel from 90° to 45° towards each other with degree markings and pointer; stops are at 90° and 45°; angular adjustment of saw head away from each other available as option; other angles possible; phenolic chip breaker included.

  • Heavy gage steel; eight foot centers with traveling right hand carriage on rack and pinion; length measuring scale; optional length centers available to 40 feet 12M; Digital Length Measurement available as optional accessory.

  • Completely encloses blade in rest position. Lower rotating blade guard pivots up into main stationary blade guard as saw heads pivot down to cut.

  • On each side of blade are keyed to base and are easily adjustable front to back, and side to side.

  • Two inside vertical clamps must be tripped by foot valve, then a two-hand anti-tie down, maintained contact safety control will work the air down feed of saw heads. An air filter/regulator/lubricator with auto drain is provided.

  • 75 PSI 5.2kg/cm2; 3 CFM at 75 PSI .09 cubic meters at 5.2 kg/cm2, based on 10 strokes per minute.

  • 32″ 81cm front to back x 64″ 163cm High x 120″ 305cm Long; Weight 1,050 lbs. 476kg.