We purchased this machine from a 79 year old who just retired. He remembers purchasing it for his small family run pattern shop in 1981. While used it has seen way less use than the average NO. 7 and has been flawlessly maintained by a proud owner. You can still see the grind marks on the tables.  Vibrant original paint and graphics. Segmented infeed rolls are in excellent condition. Truly a rare find! See below for specs. Includes, manual, grinding bar, knife grinder, &  jointing stone.  This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it.

Actual Size 25″ x 9″ Straight Knife
Cylinder 5″ cutting circle, 4 knife, high carbon steel, micrometer-type knife raising screws
Knife Size 5/32″ x 1-1/4″ x 25″ high speed steel
Drive Direct Motor
Brake Conveniently located hand brake
Motors  7-1/2 HP totally enclosed, fan cooled.

FEED: 1-1/2 HP totally enclosed, fan cooled.

Voltage 208 – 220/440, 550 volt 60 cycle, 3 phase standard
Lower Feed Rolls 4″ solid steel, power driven, sealed-for-life bearings
Upper Feed Rolls INFEED: 4″ diameter, 2″ milled ductile iron sections, 5/16″ section yield, 3/4″ roll yield, sealed-for-life ball bearings.

OUTFEED: 4″ solid steel, power driven, sealed-for-life ball bearings

Table Feed Roller Adjustment Single hand lever .001″ to .075″
Feed Speed 20 to 100 lineal feet per minute (higher or lower available in same ratio)
Chipbreaker Ductile iron, 2″ sections, concentric with head
Pressure Bar easily adjustable with micrometer type screws
Maximum Stock Width 25″ Straight Knife
Shortest Butted Piece 4″
Shortest Single Piece 12″
Maximum Stock Thickness 9″
Minimum Stock Thickness 1/16″
Maximum Depth of Cut 1/2″
Controls Double magnetic switch, single pushbutton, reversing switch on feed mechanism
Floor Space 60″ x 50″
Base Large box-type, three point mounted
Net Weight 3000 lbs.*
Domestic Shipping Weight 3100 lbs.*
Export Shipping Weight 3400 lbs.*
Cubic Export Crate Size 137 Cu. Ft.