HESS MOBIL 10′ EDGE PRESS $6,500

HESS MOBIL 10′ EDGE PRESS $6,500

6 (orange) adjustable side pressure pneumatic hold down cylinders + 6 downward pressure adjustable hold down cylinders. Both are controlled by a three 3 position levers located on every other cylinder. (down position=off, center position=engages main cylinder, up position engages hold down pressure)  Elcom Heated platen bars with adjustable thermostat. Preheater. Max edgeband that can be applied: 118″ ‘x 2-1/2″ w x 2″ thick. Uses white or yellow PVA glue. This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it.

BLACK BROS 5’X10′ ADJUSTABLE OPENING COLD PRESS SOLD

BLACK BROS 5’X10′ ADJUSTABLE OPENING COLD PRESS $$$RECENTLY SOLD$$$

Very well maintained Black Bros 5′ X 10′ side load 50 PSI air pod cold press. 62″ X 123″ of actual working area.  The top is divided into 4 platens. With two 36″ platens on the left and two 25″ platens on the right. Each platen can be individually raised or lowered. You can also use the master to raise and lower all 4 zones as well at one time. Upon lowering the platens the lower rollers will retract. Inversely as you release the pressure and end your cycle the the rollers will extend, lifting your material so it can easily exit the machine with less effort. Platens are in excellent condition. This means flat and defect free…..no dents or imperfections. PLUS they have a beautiful grind to them that is very visible. 30″ max. daylight opening. The entire machine has been cleaned along with all glue being scraped off. Naturally when removing glue, paint also comes with it so the paint has been touched up. Please note that it has only been touched up. All of the front controls, regulators, gauges, along with 7 of the poppet valves, and various hoses have been replaced and or rebuilt. This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it. We could even go as far as to say……”Good luck finding a cleaner one in this condition!

NEW JOOS HOT PRESS

NEW JOOS HOT PRESS  Contact us for a quote today!

We have seen a lot of presses. If we had a choice we would buy Joos and Joos alone. We chose Joos because of the stellar service and support Joos USA offers in addition to the the quality of every component on a Joos press. From the quality of the actual steel that makes the frame to the placement of supports. Hi end/no compromise components and engineering can be found through-out their products. You get gold anodized platens and features like their patented ABS that all but eliminates pressing incorrectly loaded or forgotten parts. Did we mention the Elkom platens! You can also choose between glycol/water, electric, or oil heated platens. Electic plates to 425 degrees (working) Fahrenheit,  high pressure plates that can reach 300 degrees Fahrenheit plus or minus 1 degree or oil plates up to 800 degrees.  One thing that is often over looked is the quality of their heaters. They offer the most stable temperatures with the minimum energy consumption. Contact us for a quote today.