WYSONG & MILES/CENTRAL MACHINERY 600 AND 601 DOVETAIL MACHINES

WYSONG & MILES/CENTRAL MACHINERY 600 & 601 DOVETAIL MACHINES $13,000

This is something you do not see everyday a rebuilt pair of Wysong & Miles 600 and 601 dovetail machines! While these are older machines they were rebuilt around 2005 by Central Machinery. They were completely gone thru and parts like gears, bearings, pneumatics, electrical (including motors and starters) along with various other parts were updated and replaced. We also cleaned, tested, and went thru the machines as well.  This should ensure that they will run for another few decades. They have a 15″ capacity and are set up to do 1/2″ dovetails. The downside is that they are loud, only set up for ½” increments, and only have a 15” capacity. The upside is if you can work with in the 15” width capacity and with in ½” increments that they are fast! You can cut up to 3 pairs of drawer sides (width dependent) and up to 2 drawer fronts at one time. They are also faster than a CNC dovetail machine! The 600, on the left is designed to do the drawer sides while the 601, on the right is designed to do drawer fronts. These fully functional machines have been fully cleaned, checked, and are ready to work from the time you receive them. Both machines come with one good set of tooling that has not been resharpened. (Meaning a lot of life left in them as well)

DODDS SE15 DOVETAIL MACHINE

DODDS SE15 DOVETAIL MACHINE $8,000

Clean strong running 15 spindle dovetail machine. 3 HP, 3,850 RPM motor 10,600 RPM spindle speed. 1/2 HP feed cycle motor automatic or manual cycling selection, (10 – 25) strokes/Min ball bearing spindles in an oil mist lubrication system. Adjustable chip breakers. Cuts all four corners, dovetails drawer fronts-and-backs or drawer sides in pairs. Complete with synchronized pneumatic hold downs, foot pedal actuation, & magnetic push button controls.

DODDS GP-26F UNIVERSAL DOVETAIL DRAWER GLUER

DODDS GP-26F UNIVERSAL DOVETAIL DRAWER GLUER $3,000

This clean dovetail gluer applies a precise amount of glue to the dovetail tenons through the use of metering pumps. The amount of glue applied is adjustable so there is no squeeze out when the drawer is assembled saving time in the assembly process. It is designed for materiel up to 28″ in width but will lock and can be used with widths up to 31″. This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it.

  • Automatic glue system cleaning
  • No tools required for set-up
  • Fast, precise operation
  • Large glue tank capacity
  • Precise metering glue pumps

DODDS C-36 DOVETAIL DRAWER CLAMP

DODDS C-36 DOVETAIL DRAWER CLAMP $5,500

Model C-36 clamps five-piece drawer design with standard English (finger type) dovetails as well as bored and doweled drawers. The C-36 features almost zero set up time using no tools. The full pneumatic capability range clamp pads require no set-up. This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it.

Features:

No tools needed for set up
Assembles several types of drawer construction
Assembles five piece
Maintain clamping pressure
Fully Pneumatic