RITTER R46 DUAL HEAD LINE BORING MACHINE

RITTER R46 DUAL HEAD LINE BORING MACHINE $6,500

Clean, well maintained, low use R46 line boring machine. Brand NEW set of tooling installed! Accurate Technologies digital read out on front head. 2 stops on the back fence, 4 flip stops for head positioning, and 2 position depth stop. No issues what so ever on this clean low hour R46. This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it. Manuals included.

  • (2) 3 HP Spindle Drive Motors, TEFC
  • (2) 23-Vertical Gear Driven Spindle Rows
  • 32mm Spindle Centers
  • 10mm Bored Collets
  • (24) Right Hand, (22) Left Hand
  • 4″-24″ Centers Between Rows
  • Digital Readout Front Head Position Display
  • Precision Linear Head Ways
  • (4) Quick Set Drill Head Position Stops
  • Rear Drill Row Nesting
  • 48″ Back Fence with (2) Stops
  • (2) Air Index Pins
  • (2) Position Drill Depth Stop Turret
  • 30″ X 48″ Work Table Surface
  • Wired 3-Phase 240/480 Volt, 60 Hz.
  • Foot Actuated Boring Cycle
  • Crated Dimensions: 54″ X 54″ X 76″ and 1341 Lbs
  • Designed and Manufactured in the USA

GRASS ECO PRESS P HINGE BORING & INSERTION MACHINE

GRASS ECO PRESS P HINGE BORING & INSERTION MACHINE $1,000

Clean fully operation Eco Press P with 2 different styles of holders for the inserter. Single Phase 115V operation. Dual flips stops and pneumatic hold downs. This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it.

KARL ENGELHART TWF 1000 STAIR TRENCHER AND MULTI BORING MACHINE

KARL ENGELHART TWF 1000 $2,500

A rare machine in North America mostly due to cost. At over $30,000 NEW it’s not hard to see why so few made it to this part of the world. Like most German made machines this one is well thought out,  accurate and precise. This well cared for machine’s motion is effertless and flawless. With nearly 62″ of x-axis travel, 48″ between rails from front spindle, 54″ from the back,  3 1/2″ of y-axis travel, and 3 1/8″ of z-axis travel this machine can do things few boring machines can. It also has the ability to bore open ended at the end of the machine. The clamping rails have rubber inserts across the top so that your work piece does not get damaged. The clamping capacity is a generous 4 1/2″ and fully adjustable. Power is provided by a 220V/3 phase 4 hp motor that has 2 speeds plus forward and reverse. Twin spindles turn counter clockwise one another and are flat belt driven. With a built in halogen work light, squaring fence, and built in castors it’s not hard to see the German engeering. Use it to trench stairs, cut slots, dados, bore holes…..lot’s of possibilities…..