COMPLETE 3 SHAPER WEAVER DOOR SYSTEM SINGLE PHASE $8,000

COMPLETE 3 SHAPER WEAVER DOOR SYSTEM SINGLE PHASE  $8,000

This is a one owner set of single phase 220V Weaver shapers. Upon picking them up the retired woodworker added that the cutters were original except the raised panel cutter. He added he had to change that once, but also included the original. This should be a good indication of use! If you think that tells the whole story take a look at the single phase 4 Roll Powermatic PH-41 Powerfeed…….that is in even better condition. Feed was never mounted to the Weavers themselves. (Includes a NEW set of ACROTEC Urethane feed wheels)  Two of the shapers have 3 HP Baldor motors while the third has a 5 hp motor. All shapers have 1-1/4″ spindles.  You will also get a #225 Coping Hold Down Tenon Jig, #310 Panel Jig, #330 Rail Jig, and 3 sets of templates. These fully functional machines have been fully cleaned, checked, and are ready to work from the time you receive them. If you are looking for a set of Weavers look no further. These have low use, were used by a single craftman, and were very well cared for. Look at the condition of the templates……….look at the condition of everything………you will be hard pressed to find a better complete set.

BALESTRINI MINI C 2500 DOUBLE SIDED TEMPLATE PROFILE SHAPER $8,000

BALESTRINI MINI C 2500 DOUBLE SIDED TEMPLATE PROFILE SHAPER $8,000

Very clean Mini C 2500. We replaced several air solenoids and installed several piston rebuild kits. This one comes equipped with a pair of Oertli 4″ X 6″ spiral insert cutter-heads. Max length 2500 mm (98.4″). Max height 180 mm (7″). Spindle speed 8400 RPM. Feed speeds 1-15 m/min. 9-3/4″ wide x 110″ long tee slotted work table. Hydraulic stroke of work table. 3HP, 230/460 volt three phase hydraulic pump. Overhead beam clamp bar with (6) adjustable clamps. (2) Offset shaping heads with 7.5 kW, 230/460 volt three phase drives. 1¼” diameter work arbors with 7″ under the nut capacity. Push button operator control station. This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it.

INVICTA TI-14 TILING SHAPER $4,000

2005 INVICTA TI-14 TILING SHAPER $4,000

This machine has had a single owner and operator. Very clean and very well maintained. 1-1/4″ spindle with 5-1/2″ under the nut. 7.5 hp main 208-230/460V main motor currently wired 230V/3 Phase. Large 35″ X 43″ cast iron table. Spindle Speeds: 3,000, 6,000, 8,000 & 10,000 RPM. Spindle tilts -5 degrees to 45 degrees and the max. table insert diameter is 13-3/4. Includes nut and full set of spacers. Weight: 1,265 lbs. This fully functional machine has been fully cleaned, checked, and is ready to work from the time you receive it.